Printer Driver Download Kyocera FS-C2126MFP
Kyocera FS-C2126MFP Printer Driver Download. First, the Kyocera FS-C2126MFP USB driver was easy to install. However, the installation / operation of the printer over the network by means of the network driver has unfortunately never worked properly. The driver is crap. Scanning over the network is a horror. The document feeder can not be used properly for scanning, so you have to load each sheet to be scanned, and you must start the scanning process manually for each additional sheet. This annoys quite quickly and costs a lot of time in the long run. And in particular the color part of the printer after 4.5 years of operation is unfortunately defective.
Driver Download Kyocera FS-C2126MFP Printer Installer
This Kyocera does not print yellow or blue any more, although the toner cartridges have already been changed several times after they were empty and are now full again. Although hardly any color prints were produced, the color print is defective. According to the internal counter, 14,000 b / w prints have been made so far and 4,500 color prints, rather little. The service technician says this is precisely the problem, which is always the case with this model. If you use the color print too rarely, then the developer unit is defective exactly because of this.
Kyocera FS-C2126MFP Driver Installer Download
Printer Driver Kyocera FS-C2126MFP Download
This is technical and a known problem. The exchange of the 2 units would now cost about 500 €. And then the units would probably be broken, if you continue to rarely make color prints. In this respect, this Kyocera FS-C2126MFP printing device is unsuitable for any application in which color printing is not carried out on a large scale every day. I perhaps regret to this purchase. Only as an emergency solution I use the printer now as b / w printer.
Driver Printer Download Kyocera FS-C2126MFP
However, even color cartridges have to be used for this, and color toner is also consumed to a small extent because the device constantly wants to perform a so-called color calibration, for which toner is consumed. This multi-minute procedure always happens exactly where it is the worst, so just a customer is there, for which you only quickly print a sheet or copy. Then one is only stupid there and explained again and again that the printer just urgently wants to make a calibration. Badly solved!
DOWNLOAD DRIVER (All Kyocera printer drivers and software from Official Source):